The Pumped Reverse Osmosis System is pre installed with RO booster pumps to supply the RO membrane with ideal pressure, ensuring optimum output from the system. This variation is a point of use reverse osmosis system, ideal for household and commercial use when high volumes of refined water are required quickly. They will improve both the aesthetics of the water as well as removing any bad tastes or odours.
Larger than our slim systems, the RO-400 utilises a third stage of pre filtration in the form of granular activated carbon. Compared with only the two stages in our slim systems, this both prolongs the life of the RO membrane inside and also work more effectively to reduce chlorine levels within your water. All RO systems can be purchased with customisable consumables. Some are designed to target specific contaminants, eg. Chloramine, and others are rated at increasing efficiencies depending on the quality of your source water, and how long you would like your filters to serve for.
Do not run a pump continuously for more than 4 hours or allow a pump to run dry. Doing so will cause the pump to overheat and become damaged. So that you do not need to manually turn the system on and off every 4 hours, we suggest installing a timer to give the pump a thirty minute break so that it will cool down. We also recommend you install a low pressure switch before your pump so that it does not run dry with little feed flow. A pump should also be mounted using the built in mounting holes to stop the pump from getting damaged through uncontrolled vibration.
If any of the above directions are not followed, the warranty of the pump will be null and void. We will ask for evidence of you following the above directions and will not issue a warranty replacement without any.