V16 Digital Flow Controller WFP Window Cleaning System Pump Controller

£120.00 £100.00
In stock

V16 Digital Flow Controller (WFP Window Cleaning System Pump Controller)
Pump Specification:
Supply Voltage - 11 - 15 VDC
Maximum Current - 15A
Typical Drive Current - 8A
Voltmeter Accuracy - +- 100mV
Enclosure Material - ABS
Water Resistance - IP65
Dimensions - 115 x 65 x 40 (mm)
Working Temperature - 0 to 40 Deg C

Adjust the flow settings carefully. Repeated false dead-end detection
indicates that the Cal value should be increased (less sensitive).
For safety wire through the pump pressure switch. (The pressure
switch can be bypassed if absolutely necessary - the unit will protect
itself under normal conditions.)

This is a WATER PUMP controller: it will not work with air in the system.
Always prime the system before starting work. If air in the system
causes false dead-end detection, increase Cal value until air is removed.
Do not set the Cal value too high. Setting it higher than necessary
places extra strain on both the pump and the controller in a dead
end situation. This can result in damage to both the pump and
your controller.

* Your battery is at risk of permanent damage if you disable low battery cutoff and continue
to use your controller for long periods when the battery voltage has fallen below +10.5V.

Please note we do have the brochure in a PDF format, if you wish to have access to this please message us.

Write Your Own Review
You're reviewing:V16 Digital Flow Controller WFP Window Cleaning System Pump Controller
Your Rating
More Information
Is Free ShippedNo