Booster Pump 12L For Window Cleaning + Pump Controller

£194.06 £161.72
In stock

Diaphragm Booster Pump 12L For Window Cleaning + Fittings

100 PSI Vyair pressure pump providing 12 Litres per minute flow with a 12V DC operation.

This is a quality pump manufactured by one of the world's leading water pump manufacturers. 

Our suppliers, realising the vast potential of the European window cleaning market, have invested substantial technical and financial resources to produce this quality pump. The pump has both been tested in the factory laboratory, and also field tested here, for many months in a window cleaning environment.  

Technical Specification

  • 12 volt 14 amps 
  • 10 litres per minute open flow rate 100PSI pressure rating 
  • 1/2" BSP female fittings supplied also with 1/2" male to barbed hose connection 
  • Suitable for use with most pump controllers 
  • Pressure switch 100psi turns off 80psi turns back on 
  • Weight 2.3kgs 
  • CE certification & Rohs Compliant
  • 12 months No Quibble service guarantee if used in accordance with designed purpose


Pump Controller Specification:

Supply Voltage - 11 - 15 VDC
Maximum Current - 15A
Typical Drive Current - 8A
Voltmeter Accuracy - +- 100mV
Enclosure Material - ABS
Water Resistance - IP65
Dimensions - 115 x 65 x 40 (mm)
Working Temperature - 0 to 40 Deg C

Adjust the flow settings carefully. Repeated false dead-end detection
indicates that the Cal value should be increased (less sensitive).
For safety wire through the pump pressure switch. (The pressure
switch can be bypassed if absolutely necessary - the unit will protect
itself under normal conditions.)

This is a WATER PUMP controller: it will not work with air in the system.
Always prime the system before starting work. If air in the system
causes false dead-end detection, increase Cal value until air is removed.
Do not set the Cal value too high. Setting it higher than necessary
places extra strain on both the pump and the controller in a dead
end situation. This can result in damage to both the pump and
your controller.

* Your battery is at risk of permanent damage if you disable low battery cut off and continue
to use your controller for long periods when the battery voltage has fallen below +10.5V.

Please note we do have the brochure in a PDF format, if you wish to have access to this please message us. 



"Pump care:

Do not run a pump for more than 4 hours continuously.

This is to stop the pump from overheating and becoming damaged.

To achieve this, we would suggest installing some form of timer, so that after 4 hours of operation the pump has a 15-30 minute break. This will enable the pump to cool down.

The warranty for the pump would be null and void if no timer is used. If there is an issue with the pump we would ask for evidence of a timer being used to allow the item to be covered by the warranty

Do not allow the pump to run dry (without an active water source) as this will damage the pump.

The only time that we would suggest running the pump without an active water supply is if you have a low pressure switch wired into the pump, as this will automatically switch the pump off when the incoming water flow is turned off.

 The warranty for the pump would be null and void if used in an application of running dry without a low pressure switch- We will ask for evidence of use of a low pressure switch to receive a warranty replacements of the pump

We suggest that the pumps are permanently mounted. This is to stop any potential for the pump to vibrate and become damaged

We will ask for evidence of how the pump is mounted for the item to be covered by its warranty.

This is not designed to be used as a window cleaning pump, only designed for water transfer. If used in window cleaning warranty will be void"

Write Your Own Review
You're reviewing:Booster Pump 12L For Window Cleaning + Pump Controller
Your Rating
More Information
Is Free ShippedNo