EcoAqua EFF-6013A Compatible with GE Smartwater Fridge Filter & More

This is an EcoAqua EFF-6013A fridge filter, which is compatible with a range of GE Smartwater fridges; for a comprehensive list of compatible models, please see the 'What will it fit?' tab. As GE MWF filters are quite uncommon in the UK, this compatible filter is an ideal and effective solution.

The filter makes use of an NSF & WRAS approved sintered carbon block to filter out chlorine, particulates and sediment, and provides the same level of filtration as the manufacturer’s original. We keep this part in stock and is ready for immediate dispatch. 

To ensure the purity of the water, we recommend that this filter is replaced every 6 months.

Technical Specifications:

• Flow Rate: 1.9 lpm (0.5 gpm)
• Operating Pressure: Min. 140 kPa (20 psi) / Max. 827 kPa (120 psi)
• Operating Temperature: Min. 0.6 °C (33 °F) / Max. 38 °C (100 °F)
• Capacity: 1,325 litres (350 US gallons)

Installation and replacement procedure for the EFF-6013A fridge water filter:

• Slowly turn the old cartridge 1/4 turn to the left (counter clockwise). Note: Do not pull down on the cartridge.
• Remove and discard the old filter (the water will shut off automatically).
• Peel off the protective cover from the new cartridge.
• Fill the new replacement cartridge with cold water to allow for better flow immediately after installation (you can use tap water).
• Line up the arrow on the cartridge with the cartridge holder. Note: Do not force it up into the holder.
• Turn the filter 90 degrees right (clockwise) until the cartridge stops. Do not over tighten.
• Run water through the dispenser for 3 minutes to purge the system.
• Check the filter area for leaks.
• Reset the filter status light by pressing and holding the Reset Water Filter button for 3 seconds.