10" Melt Blown PP Sediment Filter (removal ratings from 1 to 50 micron)

  • WQA approved product
  • 85% efficiency at stated nominal micron rating
  • Multi-layer construction gives true graded depth filtration, high dirt holding capacity and long service life
  • Constructed from 100% polypropylene without added binders, resins or adhesives
  • Chemical resistant and prevents development of microorganisms
  • Provides excellent filtration with low inlet pressure
£4.87 £4.06
In stock
Product Tags :

VYAIR PP series cartridges are WQA certified using FDA approved polypropylene for material requirements.

The construction of this pure polypropylene, surfactant-free depth filter ensures low pressure drops, with exceptional dirt holding capabilities. PP uses no resin binders, lubricants, antistatic or release agents or other chemical additives.

The one-step manufacturing process continuously extrudes and thermally bonds pure polypropylene microfibres into a complex filter matrix.

Cartridges are characterized by excellent sediment absorption of sand, silt, rust and suspended solids from potable water.

Polypropylene fibers are chemical resistant and prevent development of microorganisms. In addition, these filter cartridges effectively protect expensive home appliances and residential plumbing systems.

PP series cartridges are an ideal true depth filters and can be used for filtration of cold potable water.

VYAIR's wide range of melt-blown cartridges have multiple fibre zones. These multi-fibre zones provide a graded pore structure throughout the filter’s depth. Our filter cartridges have been designed to capture and retain contaminants throughout the entire cross section of the filter.

The multiple fibre zones give our filter cartridges a major competitive advantage over other melt-blown filters with fewer pore size gradients in their structure.

VYAIR's melt-blown filters demonstrate true graded depth filtration, the results are long filter service life, therefore lower consumable costs.

The new, modern, automatic manufacturing equipment used to produce our wide range of melt-blown cartridge filters delivers consistently efficient filters at low costs.


  • Filter media: PP
  • Min. feedwater temp. 2°C (35º F)
  • Max. feedwater temp. 80°C (176ºF)
  • Nominal micron rating: 1, 5, 10, 20, 50
  • Maximum flow rate: 20 lpm (5.29 gpm)
  • Rated capacity: 12,000 litres (3,170 gallons)
  • Length: 10" (256 mm)
  • Outer diameter: 2.5” (62 mm)
  • Filter life: 3 - 6 months
  • Inner diameter: 1.1”
  • Avg. Efficiency: 90%

IMPORTANT NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. We recommend regularly scheduled maintenance and replacement of the filter cartridge in order for the product to perform properly.

Write Your Own Review
You're reviewing:10" Melt Blown PP Sediment Filter (removal ratings from 1 to 50 micron)
Your Rating