Maximum temperature: 60 degrees Celcius
Typically used in the right hand canister of the filter system.
Block Carbon Filter (CTO)
The combination of the ultimate in plastics extrusion and activated carbon technologies has transformed the future of carbon filtration. By incorporating powder carbon and small mesh structures with extrusion manufacturing methods, clean, consistent and economic filters termed ‘CARBON BLOCK’ are created. longer life, higher flow, no channelling, lower extractables, fine filtration, plus they are cleaner and more versatile. This is a 5 micron carbon block filter used for the removal of chlorine and certain heavy metals and contaminants. They are particulalry important for the removcal of chlorine from water to protect your RO membranes
We recommend that these filters are changed 1-6 months depending on output capacity & actual use and water output. The idea is to keep Chlorine off your membranes
This does depend upon the throughput of your RO System. Do not exceed these times or you may find that chlorine has oxidised your membranes requiring a complete replacment of reverse osmosis (RO) membranes.
After fitting the filters, disconnect the pre-filter output from your RO housing and allow to flush approximately 5-10 minutes reconnect and start making water. This helps remove any particles from the new carbon filters and protects your membrane, if you get the small particles of carbon on your RO membrane is will cause the membrane to clog and results in early reduced flow rates. Please not it is quite normal for all new carbon filters to lose some carbon dust.
These filters are made to NSF Standards and manufactured by ISO9001 company a member of WATER QUALITY ASSOCIATION OF AMERICAN.
All Categories
