Reverse Osmosis Water Fed Pole Pure Water Filter RO

FREE SHIPPING TO UK POST LOCATIONS

•  NEW 10" 5  Reverse Osmosis 3 Filter Set

  1 x5 micron Sediment filter

   1 x GAC Granulated Activated Carbon filter

   1 x (CTO)Carbon Block filter

   
  Fits most 10” Water Fed Pole Window Cleaning & Fishkeeping Filter Systems including RO-MAN

   Sediment Filter

  Replacement particulate filter for 10" filter housing.
  Polypropylene Filter for the removal of sand, silt, dirt other particles.
  5 micron
  Maximum temperature: 60 degrees Celcius
   Typically used in the right hand canister of the filter system.
  
   
   
  GAC Granulated Activated Carbon Filter
  In the GAC filter, water flows through a filter full of activated carbon granules which  remove chlorine, organic contaminants, chemicals, and undesirable tastes and odours.This is based on providing maximum surface area of carbon granules exposed to your water. 
    

  It is important that this filter is fitted with the rubber seal upwards (most filters are water fed from the top)

   
   Block Carbon Filter (CTO)
  The combination of the ultimate in plastics extrusion and activated carbon technologies has transformed the future of carbon filtration. By incorporating powder carbon and small mesh structures with extrusion manufacturing methods, clean, consistent and economic filters termed ‘CARBON BLOCK’ are created.  longer life, higher flow, no channelling, lower extractables, fine filtration, plus they are cleaner and more versatile. This is a 5 micron carbon block filter used for the removal of chlorine and certain heavy metals and contaminants.  They are particulalry important for the removcal of chlorine from water to protect your RO membranes
   
  We recommend that these filters are changed 1-6 months depending on output capacity & actual use and water output.  The idea is to keep Chlorine off your membranes
   
  This does depend upon the throughput of your RO System. Do not exceed these times or you may find that chlorine has oxidised your membranes requiring a complete replacment of RO membranes. 
   
  After fitting the filters, disconnect the pre-filter output from your RO housing and allow to flush approximately 5-10 minutes reconnect and start making water. This helps remove any particles from the new carbon filters and protects your membrane, if you get the small particles of carbon on your RO membrane is will cause the membrane to clog and results in early reduced flow rates. Please not it is quite normal for all new carbon filters to lose some carbon dust.